OPTIONS
PAGE 40 / 70
NXAMPMK2 USER MANUAL
INPUT PINS CONFIGURATION
In Custom Mode, to configure the input pins (control functions), press GPInputs. Input pins are numbered
from GPI 1 to GPI 5.
Then choose a parameter (see table below, e.g. Switch Scene), then if needed a first and a second option
(e.g. the Scenes to switch). Finally, choose if this action should be triggered when
the pin’s state is high,
low, or on impulse (there is no threshold).
Note that an action based on a permanent state (e.g. Stand-
by) is only validated after the pin’s state has
changed and is stable during 1 second.
In case there is competition between input functions (e.g. GPI1 is mute ON and GPI3 is mute OFF), note
that treatment is sequential (in this example, mute OFF wins).
Name
Short Name
Options
Possible States
Description
Low
High
Imp.
Power amp
start
Started
X
NXAMP will wait till pin goes to the chosen state
to start the amplifier part (big power supplies).
Then the pin stays at the chosen state, so
several amps. can be linked together.
Switch
scene
Scenes Sw.
Scenes A
and B
X
X
X
Recalls a scene or another, or toggle between
two scenes. If "Active on High": scene A is
recalled when GPI is low, and scene B is
recalled when GPI is high. If "Active on Low", it
is the opposite.
Analog
inputs Mute
Mute An. In
X
X
X
Mutes or unmutes the analog inputs.
Digital
Inputs Mute
Mute Di. In
X
X
X
Mutes or unmutes the digital inputs.
Stand-by
Stand-by
X
X
X
Put the NXAMP in stand-by mode or back to the
running mode. In case of Impulse mode, the
action is triggered only after 3 seconds.
Volume
Increase
X
Relatively increases the volume of all the
channels, see documentation for the steps.
Even if max volume is reached on a channel,
continues incrementing volume on other
channels. And when start decreasing, the value
differences between the channels are restored.
Volume
Decrease
Volume -
X
Relatively decreases the volume of all the
channels, see documentation for the steps.
Even if min volume is reached on a channel,
continues decrementing volume on other
channels. And when start increasing, the value
differences between the channels are restored.
Overmute
Overmute
X
X
X
Mutes or unmutes all the output channels.
Attenuate
Attenuate
X
X
X
Attenuates of 20dB or not all the output
channels.
Summary of Contents for NXAMP4x1mk2
Page 68: ...USER NOTES PAGE 68 70 NXAMPMK2 USER MANUAL USER NOTES ...
Page 69: ......
