Nexo NXAMP4x1mk2, User Manual

Page: 35 / 70

OPTIONS
NXAMPMK2 USER MANUAL PAGE 35 / 70
Since the introduction of the NXDT104mk2 (Dante TM ) and NXAE104 (AES/EBU), a network switch is
included on the extension card connecting the amplifier directly to the network. So, with any of these 2 cards,
the card has an IP address and the NXAMPmk2 has also an IP address.
For example, with NXDT104mk2 card, the I
P address on Dante™ Controller is the card IP address (used
for audio network), and the IP on NeMo is the amplifier IP address (used for remote-control).
DEVICE ID
Here can be modified the NXAMPmk2 Device ID.
The Device ID is composed of one ‘Y’ letter followed by 3 characters, with each character between 0 and 9
(for digits) or between A and F (for letters), so for example “Y01 ”.
The Device ID is always included in front of the Dante™ card name on the Dante™ network. On the following
Dante™ Controller screenshot , we can see that the Dante™ card name is “Y01 -NEXO-NXAMP4x4mk2-
062c60”.
The Device ID can be edited on Dante™ Controller by editing it directly in the Dante™ card name.
NAME
Here can be modified the NXAMPmk2 name, used and displayed by the remote-control software (NEXO
NeMo).
NB:
The NXAMPmk2 name is not the same than the Dante™ card name, but a function is available in NeMo
to sync them on request (see NeMo user guide).
MODE
Here can be modified the NXAMPmk2 IP mode. 2 modes are available: “Static” or “DHCP AutoIP”.
•
“DHCP AutoIP” mode is the default one and the recommended one to get the network working easily.
When the amplifier starts, it asks an IP address on the network using a DHCP request. If no DHCP
server answers by giving an address, the amplifier switches automatically in Auto-Addressing mode and
takes an IP address in the auto-assign form
“16 .25 .xxx.xxx”.