Nexo NXAMP4x1mk2, User Manual

Page: 19 / 70

SETTINGS MENU
NXAMPMK2 USER MANUAL PAGE 19 / 70
SETTINGS MENU
DEFAULT VU-METER MENU DESCRIPTION
1: Speaker preset, the first
line shows the Speaker name (here “S118”) and the Speaker mode if any (here
“OM” for Omnidirectional) while the second line shows the selected frequency range (here 30 Hz to 120 Hz).
The Speaker Mode can be one of the following:
On Screen MODE display MODE signification
WB Wideband setups (lower high-pass filter)
XO Cross over setups (higher high-pass filter)
PA Passive mode (on products providing an active/passive mode)
AC Active mode (on products providing an active/passive mode)
MON Monitor setups (Specific phase response, minimized latency)
BR Bridge mode
OM Omnidirectional mode (on products allowing Omni/Cardio switching)
CD Cardioid mode (on products allowing Omni/Cardio switching)
FR Channel used for Front speaker in Cardioid mode
BA Channel used for Back speaker in Cardioid mode
B2B Back to back mode (on products requiring two cabinets for Cardio)
S2S Side to side mode (on products requiring two cabinets for Cardio)
DF Down Fill (for line array used in Downfill application)
2: Vu-meter of the amplifier channel output voltage. Scale is from -60dB to 0dB (relative to the amplifier
output clip).
3: Vu-meter of the gain reduction applied if the speaker protection is active. Scale is 0dB to 24dB.
4: Mute, this is an individual mute for each channel of the amplifier.
5: Dual colour led, which can be green or orange. Green means that the amplifier detects some current on
the output, indicating (when there is signal) that a speaker is connected. Orange means that the speaker is
being protected (when vu-meter 3 is above 0dB).
6: Channel number
5
2
1
6