Nexo NXAMP4x1mk2, User Manual

Page: 21 / 70

SETTINGS MENU
NXAMPMK2 USER MANUAL PAGE 21 / 70
INPATCH AND OUTPATCH
Once the Speakers preset have been recalled, and back to the default screen, press t
he “Up navigation
button” (2) to enter the input patch
For each channel press the area just above the Speaker Preset Name (surrounded for Channel 1) and select
among the eight available inputs (from A to H). Inputs A to D corresponds to the four analog inputs at the
back of the amplifier, whereas the input E to H corresponds to the four digital inputs from the optional digital
input card. A vu-meter is available for each input in the top part of the screen.
Additionally, an alignment delay can be added to any of the inputs (Analog or Digital) to ensure perfect
matching of latency using Analog or Digital inputs, depending of your cabling architecture and source
devices. This alignment delay can be setup by pressing the button just next the Global Mute Button.
CHECKING THE OUTPUT PATCH
From the default screen, the Speaker Preset Name (1) will blink alternatively with the output letter and the
output pinout (1+/1- or 2+/2- of the NL4 connector). Check that the NEXO Speakers are correctly connected.
Send some low-level audio or test signal into the NXAMPmk2 and check that each Speaker or Sub is
outputting a non-distorted sound (you might need to check the channel output volume first, see next
paragraph).
Once this has been checked, the system is ready to use. Extra settings like Gain, delays or EQs can be
applied to tune up the sound further.
VOLUME
Select a channel (button is highlighted), then turn the wheel to change the volume setting. You can select
multiple channels, when a selected channel reaches the maximum value, it will cease to increase by