- 32 -
www.NewLeader.com
(800) 363-1771
301321-AA-I
SUPER P
Installation Instructions Continued
Filling Hydraulic System
DO NOT attempt to run pump without first filling hydraulic oil tank and opening suction line
valve, or damage to pump may occur�
Fill hydraulic reservoir with hydraulic oil as specified in the “Lubrication and Maintenance” section in the
operator’s manual� Be sure oil is clean, free from dirt, water and other contaminants�
Lubricate all points necessary per Lubrication Chart in “Lubrication and Maintenance” section of
operator’s manual�
Light Installation
All holes in truck cab walls, floor and firewall are to be grommeted, plugged and sealed
to prevent entrance of engine fumes, dust, dirt, water and noise� Failure to follow this
requirement may result in injury or machine damage�
Light installation must comply with all applicable requirements prescribed by FMVSS/CMVSS 108,
ASABE S279, state and local regulations� See “Lights” parts page in the operator’s manual for
illustrations if applicable�
Inverted “V”
Lower Inverted “V” into spreader hopper and install with supplied hardware� Refer to “Inverted “V””
parts page in parts manual for details�
Screens
Optional hopper screens are available to break up material chunks as hopper is loaded� See “Screens”
parts pages for details�
Light Duty/Heavy Duty Screens
Light Duty/Heavy Duty screens require no hardware� Ensure that angles are tight against hopper side
sheets and that screen is sitting flat and securely.
Flip-Up Screens
Install Pivot on top of side sheets and center
from front to back� Install clamps (1) with supplied
hardware to hold in place to side sheets as shown
in Figure 6� Install screens to pivot using supplied
hardware� See “Screens - Flip-Up” parts page for
details�
1
Figure 6
