- 29 -
SUPER P
www.NewLeader.com
(800) 363-1771
301321-AA-I
Installation Instructions Continued
Figure 5
Engine Harness
1� Figure 4 - Connect the two-wire supply harness from the control panel to the truck�
• Connect the black wire to a +12V switched ignition source� It is protected by a 10A fuse built into
the control panel�
• Connect the white wire to a clean chassis ground, or directly to the negative battery terminal�
2� Connect engine harness as shown in Figure 5� Connect 7 pin RV connector to control panel harness�
Hydraulic Drive
Control Valve
Mount the control valve in truck cab following considerations on previous page�
• Refer to “Hydraulics” section of parts manual for hydraulic system illustrations�
•
An optional pedestal mount is available for the dual control valve. Refer to “Pedestal Mount Kit” in
the parts manual for details�
Route Hydraulic Hoses from control valve as follows:
To/From
Dual Control Valve
Single Control Valve
Pressure
P
IN
Return to Reservoir
T
EX
Spinner Motor
S
CF
Conveyor Motor
A
