- 26 -
www.NewLeader.com
(800) 363-1771
301321-AA-I
SUPER P
Installation Instructions Continued
Spinner Hopper Installation
Stay out from underneath spinner assembly when it is supported by hanger rod� Watch
out for pinch points between the spinner assembly and the spreader or truck frame�
Failure to comply with this requirement could result in death or serious injury�
Spinner must be in lowered and locked position when vehicle is moving� If the spinner
lowers inadvertently, component damage or serious injury could occur� Failure to comply
with this requirement could result in death or serious injury�
Spinner disc should be approximately 18” (46cm) above the ground. If spinner is significantly higher than
18” (46cm), a 12” (31cm) extended hopper assembly is available� See “Spinner Hopper - Extended” parts
page in parts manual�
2
1
Figure 2 - Standard Spinner Hopper
1
2
3
4, 5
6
7
Figure 3 - Flip-Up Spinner Hopper
Standard Hopper
1� Position and install Spinner Hopper (1) to to rear of spreader using supplied hardware�
2� Loosen Bearing hardware (2) and and adjust shaft as necessary to install and tension Drive Chain�
See Figure 4�
Flip-Up Hopper
1� Position and install Wrap Panel (1) to rear of spreader using supplied hardware�
2� Loosen Bearing hardware (2) and and adjust shaft as necessary to install and tension Drive Chain�
3� Align Mounting Ears of Hopper (3) with Wrap Panel (1) and secure by installing Spinner Rod (4) on
one side and secure with Hairpin (5)�
4� Loosen Lower Spinner Shaft Bearing hardware (6) and align Lower Spinner Shaft with Upper Shaft
(7)� Rotate Lower Shaft as necessary to couple shafts�
5� Secure opposite side of Spinner Hopper by inserting second Spinner Rod and secure with Hairpin�
6� Ensure Lower Spinner Shaft is vertical and properly aligned with Upper Shaft� Adjust bearings as
necessary�
