- 35 -
SUPER P
www.NewLeader.com
(800) 363-1771
301321-AA-I
Initial Start-Up
Check over entire unit to be sure all fasteners are in place and properly tightened per “Standard Torques”
in this manual� Check to ensure that load straps/chains are tight and that unit is securely mounted in the
truck�
Prior to testing the unit, ensure the controller is in the off position� Do not load the hopper�
1� Check to be sure that no loose parts or other material is in the hopper body, spinner hopper or on the
spinner disc�
2� Raise the feedgate until it is completely clear of the conveyor�
Auxiliary Engine Driven Units
3� Check the oil level in the auxiliary engine crankcase� Add oil if necessary� Refer to “Lubricant &
Hydraulic Oil Specifications” in the Lubrication and Maintenance section of this manual, or the engine
manufacturer’s manual�
4� Be sure all bearings, shafts and gearcase are properly lubricated�
5� Check for proper alignment between conveyor and spinner sprockets and between engine and
conveyor sprockets� Ensure sprocket set screws are properly tightened�
Ensure drive chain tension is correct� Refer to
“Installation” section for details�
A loose drive chain will cause shock loads, resulting
in damage or failure of related components� Over-
tightening of drive chain causes excessive wear and
heat, greatly reducing chain and sprocket life and
may cause damage to other components of the drive
system�
Figure 1 - Adjusting Chain Tension
Stand clear of moving machinery� Failure to comply with this requirement could result in
death or serious injury�
6� Start auxiliary engine and allow it to warm up to operating temperature at idle speed� Actuate electric
clutch switch if so equipped�
7� Bring auxiliary engine up to speed� Conveyor and spinner should operate smoothly at normal operating
speeds�
Stay clear of the spinner when it is operating� Failure to comply with this requirement
will result in death or serious injury�
Shut down engine before servicing unit� When making adjustments to the engine that
require it to be running, remove the drive chain before performing the service�
