Monitoring
110
ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
The following table explains the fields of the System screen:
Setting
Description
Access Point Information
Access Point Name
The NetBIOS name. For information about how to change the default name, see
Configure Basic General System Settings and Time Settings
on page
20.
Ethernet MAC Address
The MAC address of the wireless access point’s Ethernet port.
Wireless MAC Address
for 2.4GHz
The MAC address of the wireless access point’s 2.4 GHz radio.
Wireless MAC Address
for 5GHz
The MAC address of the wireless access point’s 5 GHz radio.
Country / Region
The country or region for which the wireless access point is licensed for use. For
information about how to change the country or region, see
Configure Basic General
System Settings and Time Settings
on page
20.
Note:
It might not be legal to operate this wireless access point in a country or region
other than one of those identified in this field.
Firmware Version
The version of the firmware that is installed.
Serial Number
The serial number of the wireless access point.
Current Time
The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings
on page
20.
Current Settings
For information about how to change any of these IP settings, see
Configure the IP Settings
on page
21.
IP Address
The IP address of the wireless access point.
Subnet Mask
The subnet mask for the address of the wireless access point.
Default Gateway
The default IP gateway for the wireless access point communication.
DHCP Client
Enabled indicates that the current IP address was obtained from a DHCP server on
your LAN network. Disabled indicates a static IP configuration.
Current Wireless Settings for 802.11b
,
802.11g
, or
802.11ng
and
Current Wireless Settings for 802.11a
or
802.11na
Note:
The section heading depends on the configured wireless mode.
Access Point Mode
The operating mode of the wireless access point. One of the following modes is
indicated:
•
Access Point
•
Point-to-Point Bridge
•
Point-to-Point Bridge with Access Point
•
Multi-Point Bridge with/without client association
For information about how to change the mode, see
Configure Wireless Bridging
on
page
88.
