NetBotz wallbotz 500, User Manual, Page: 63 / 80

56
Installing Hardware Options
3. Set the setup switches to the desired values. There are 4
jumper switches, labeled SETUP , located on the back of the
pod. The settings that correspond to each jumper switch are:
4. Connect the device for which power will be controlled to
the outlet located on the back of the Power Control Pod.
Switch Function Up Down
1 Data Rate: Sets the
communication
speed (baud rate)
between the pod and
the WallBotz 500.
2400 bps
(see
important
note, below) 9600 bps
2 Spare - -
3 Power Up Default:
In the event that
power supply to the
pod is interrupted,
determines the
power supply state
that will be used
when power is
restored.
On (power is
“On” when
the power is
restored,
regardless of
state when
power was
interrupted) Last (power
is set to the
state that it
was in prior
to the power
interruption)
4 Spare - -
When installing Power Control Pod 110s or
230s, you
must configure the pod to run in
2400 bps mode. To do this, change the
setting of SETUP switch #1 on each pod to
the “up” position and then power cycle the
module.