NetBotz wallbotz 500, User Manual, Page: 53 / 80

46
Installing Your Appliance
Installing with One or Both Pods
Tethered
Before proceeding, be sure to refer to the instructions on how to
dock and undock pods, as well as the various appliance ports and
connections in “The WallBotz 500: A Closer Look” on page 9.
After undocking one or both pods install the WallBotz 500 base
station using the instructions in “Installing with Both Pods
Docked” on page 43 (if you have undocked the Camera Pod 120,
skip Step 1, Mounting the Door Switch Sensor). Then, refer to
the appropriate sections for instructions on installing tethered
pods.
Note: You do not have to undock both pods: You can leave one pod
docked, but install the other separately and tethered.
Installing an Undocked Camera Pod
120
To install and tether an undocked NetBotz Camera Pod 120:
1. Mount the Door Switch Sensor that is included with the
WallBotz. Complete these steps to mount the switch:
a.
Measure the distance between the location where you
intend to mount the switch and the location where you
will install the Camera Pod 120. Ensure that the Door
Switch Sensor cable is long enough before continuing.
b.
Using one of the included adhesive strips, attach the
wired portion of the door switch to the door frame.
When mounting this portion of the switch, ensure that
the flat side of the switch is flush with the door frame.
c.
Using another adhesive strip, mount the non-wired
portion of the switch to the door. Be sure to mount the
second piece of the switch so that when the door is
closed the two portions of the switch are as close to each
other as possible.
Note: Once both pieces of the door switch are mounted, there must be
no more than 1/4” of space between the two pieces when the
door is closed.