Nellcor OXIMAX N-600X Series, Service Manual, Page: 70 / 210

Operating the Oximeter
70
10030881 Rev. B 12-2008
Service Manual
To change the displayed language setting
1. With the oximeter in the normal monitoring mode, press the SETUP softkey.
2. Press the NEXT softkey.
3. Press the LANG softkey.
Figure 28.
Displayed Language Selection Screen
4. Use the ADJUST UP or ADJUST DOWN keys below the ALARM SILENCE key on the oximeter
panel to select the desired language.
5. Press the EXIT softkey.
Note:
The selected language displays until the oximeter is turned OFF. Any changes in language selection do
not last beyond power-off, but return to default English, unless qualified service personnel set the
selected language as a default by following the procedures outlined in
Service Function Menus
, page 130.
1.
COMM Menu
—From the SETUP menu, press the NEXT softkey. Use the SELECT
softkey to toggle between the baud rate and communication protocol. Arrow up
or down to select the proper baud rate. Baud rates include 19200, 9600, and 2400
baud for all protocols except SPDout, which allows 115200, 57600, and 19200
baud. Arrow up or down to select the proper communication protocol. The
OxiMax N-600x pulse oximeter provides a bedside monitor communication for
interfacing with the protocols listed below. The factory default protocol is ASCII.
Table 13.
Communication Protocol Options
Communication
Protocols
N-600x using up to
Firmware 2.0
Default Baud Rate
N-600x with Firmware 2.0
and above
Default Baud Rate
ASCII 9600 9600
CLINICAL 19200 19200
GRAPH (Graphics) 9600 N/A
OXINET 9600 N/A
PHILIPS 19200 19200
Use only 19200
SPACELBS (Spacelabs) 9600 N/A
MARQ (GE Marquette) 9600 N/A
DATEX (Datex-Ohmeda) 2400 N/A
SPDout N/A Default 115200
Available:
19200, 57600, 115200
To Purchase, Visit Avobus.com or call 1-800-674-3655