Nellcor OXIMAX N-600X Series, Service Manual, Page: 149 / 210

Prompts, Error Messages, and Error Codes
Service Manual
10030881 Rev. B 12-2008
149
560 Memory corruption detected.
561 RTOS Resource unavailable.
562
%SpO
2
front end
%SpO
2
front end reset.
563 %SpO
2
reported error.
564 Clinical mode was exited after input was received.
565 Comm Communication failures between software modules.
566
UIF
Excessive resets before UIF runs.
567 An unexpected interrupt has been asserted.
568 General failure in UIF module generic post.
569 BOOT application program is corrupt - CRC does not match.
570 RTC was restarted.
574 Excessive restarts within one minute.
575 Trend data Trend data corrupted
576
LPS
Logic Processing Board (LPS) is going through excessive resets.
577 LPS status messages not arriving in a timely manner.
578 LPS driver has received too many corrupt (protocol error) messages.
579 Status report AC OK bit does not equal the hardware AC OK signal.
580 LPS driver received only a partial LPS message.
581 Too many corrupt (invalid data) message.
582 Unable to enter shelf-mode, this could mean that the LPS is dead or there
is a serial port transmit problem.
583 Speaker Primary speaker failure detected.
650
Module
Oximetry module reports internal software consistency check failed.
651 Oximetry module reports software functions executed before
initialization completed.
Table 26.
Error Code Listing for Non-correctable Failures
Error Code Category Description