Using Your NEC Versa 4-9
Installing a Device in the VersaBay II
Use the following steps to install a device in the VersaBay II. These steps
show how to install the 20X CD-ROM reader that ships standard with the
system. Use these steps to install other devices as well.
NOTE
A CD-ROM reader installed in the VersaBay II must be speci-
fied as a slave device in the BIOS Setup utility. Check that the
switch on the back of the reader is set to S for Slave.
If you install a hard disk drive from a Versa model E, V, M, or P in
the VersaBay II, it becomes the master drive from which the system
boots.
Your system must be powered off before removing or inserting devices in the
VersaBay II.
NOTE
To use a hard disk drive in the VersaBay II, the drive must be
connected to the appropriate adapter. See the
Versa Tools Catalog
or your authorized NECCSD dealer for details about the Hard Disk
Drive Cradle Pak.
1.
Make sure the NEC Versa is powered off, all options are disconnected,
and the LCD panel is closed.
2.
Turn the system upside down.
3.
Locate the VersaBay II release latches on the bottom of the unit.
4.
Slide the front latch towards the hard disk drive side of the system and
hold it.
Summary of Contents for VERSA 6220 - SERVICE
Page 197: ...Index 6...
