NEC Univerge SV8100 DT310, User Manual

Page: 62 / 78

54
8. Press Hold .
9. Press the Speaker key to hang up.
Line Keys/Programmable Function Keys
The following functions can be assigned to Line Keys if
allowed by Class of Service.
To Program a Line key as a Programmable Function
Key:
1. Press the Speaker key.
2. Dial Service Code 751 .
3. Press the Line Key to be programmed.
4. Dial the code for the desired feature plus additional
data if required.
5. Press Speaker to hang up.
Note 1:
Service Code 00 will erase the function from
the key.
Note 2:
In some cases, the Hold key needs to be
pressed before pressing the Speaker key .
Use this
keypad
digit....
Key for Entering Names
When you want to....
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ
¨
Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c 2
3 Enter characters: D-F, d-f, 3
4 Enter characters: G-I, g-I, 4
5 Enter characters: J-L, j-l, 5
6 Enter characters: M-O, m-o, 6
7 Enter characters: P-S, p-s, 7
8 Enter characters: T-V, t-v,8
9 Enter characters: W-Z, w-z,9
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü á å è
* Enter characters:
+ , - . / : ; < = > ? B E ó S ¢ £
# # = Accepts an entry (only required if
two letters on the same key are
needed – ex: TOM). Pressing # again
= Space.
Conf Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Name).
Exit Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Number, this
clears both the number and name).