Setup and Operation 2-29
n
Save Changes.
The following sections describe each of the options on the Exit Menu. Note that
Esc
does not exit
this menu. Select one of the items from the menu or menu bar to exit.
Save Changes & Exit
After making the selections on the Setup menus, always select Save Changes to Non-Volatile
RAM (NVRAM) to make them operative.
Unlike standard RAM memory, NVRAM is sustained by the RTC/battery module and stays on
when the system is turned off.
After saving the selections, the program displays this message:
Values have been saved to CMOS
Press <space> to continue
If an attempt is made to exit without saving, Setup asks if the changes should be saved
before exiting.
During bootup, Setup attempts to load the values saved in NVRAM. If the values saved in
NVRAM cause the system boot to fail, reboot and press
F2
to enter Setup. In Setup, the ROM
default values (as described below) can be loaded or the values can be changed that caused the
boot to fail.
Discard Changes & Exit
Use this option to exit Setup without recording any changes.
Get Default Values
To load all the default Setup values in the Setup menus, select Load ROM Default Values from
the Main Menu. The program displays this message:
ROM default values have been loaded!
Press <space> to continue
If, during bootup, the BIOS program detects a problem in the integrity of values stored in
NVRAM, it displays these messages:
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
Summary of Contents for PowerMate VP75
Page 147: ...Desktop Repair 5 21 ...
Page 173: ...Minitower Repair 6 25 ...