Paragon F6SR, Assembly Instructions

Page: 1 / 2

1-800-451-8546 www.paragoninc.com
ASSEMBLY INSTRUCTIONS: 24”D SEMI-RECESSED WORKSTATIONS (F6SR)
HARDWARE
QUANTITY PART NUMBER DESCRIPTION
4 1010530 FLOOR GLIDE
2 1010535 RUBBER GROMMET
4 1010541 3/8-16 X ½” SET SCREW
4 1010545 10/32 LOCKNUT
1 1010549 3/16 HEX KEY
4 1010550 ¼-20 LOCKNUT
28 1010555 10/32 X ½” MACHINE SCREW
4 1010566 ¼-20 X1 ¾” MACHINE SCREW
OTHER TOOLS REQUIRED: CORDLESS HAND DRILL WITH TORQUE CONTROL, PHILLIPS DRIVE
BIT, PHILLIPS SCREW DRIVER, AND 7/16 WRENCH.
INSTRUCTIONS
1. Preassemble keyboard trays per their separate instructions and hardware.
2. Lay top face down on a clean, scratch free surface.
3. Install keyboard trays using hardware provided with the keyboard tray and the cordless screw gun. Set
the torque control to the lowest setting to fully drive the screws into the top without over tightening. Over
tightening will cause the screw to strip, damaging the top.
4. Fully extend the keyboard tray and place the FPSR tub over the corresponding hole patterns. Tighten
the FPSR tub to the top using the 10/32 X ½” machine screws.