6-4 Setting System Board Jumpers
11.
If you removed any expansion boards, replace them
(see “Installing an Expansion Board” in Chapter 5).
12.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see Chapter 4, System BIOS and Utilities).
RECOVERING THE BIOS
The following sections describe how to recover the system
BIOS. A recovery diskette is required to recover the BIOS.
See the NECCSD Bulletin Board Service for system BIOS
information.
1.
Turn off the power and unplug the system and any
peripherals.
!
WARNING
Turn off the system before you change any jumper
settings.
2.
Remove the access cover (see “Removing the Access
Cover” in Chapter 5).
3.
Locate the Configuration jumper (J8A1) on the system
board (see “Locating the Jumper” in the previous
subsection).
4.
If necessary, remove any installed expansion boards to
access the jumper (see “Removing an Expansion Board”
in Chapter 5).
5.
Remove the jumper block from pins 1-2. We recommend
that you use needle nose pliers to move a jumper.