Setting System Board Jumpers 6-5
6.
Replace the access cover (see “Replacing the Access
Cover” in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system.
The system attempts to recover the BIOS. A recovery
diskette is needed.
9.
Power off, unplug the system and monitor, and remove
the access cover.
10.
Replace the jumper block on pins 1-2.
11.
If you removed any expansion boards, replace them
(see “Installing an Expansion Board” in Chapter 5).
12.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see Chapter 4, System BIOS and Utilities).
