NEC N8100-1422F, User Manual

Page: 249 / 414

Troubleshooting 8-11
The DISK lamp indicates the drive status as follows.
„
Lighting green
The hard disk drive is installed and powered on.
„
Blinking green
Indicates that the hard disk drive is accessed.
„
Lighting amber
Indicates that the installed hard disk drive is defected.
NOTE:
While hard disk drives are in the RAID System configuration
(RAID1, RAID5, RAID6, RAID10, or RAID50), a single failed hard
disk drive does not affect the operation of the server. However, it is
recommended to replace the failed hard disk drive and auto-rebuild
(reconfigure) the hard disk drives as soon as possible. (You can hot-
swap such a failed hard disk drive.)
„
Slowly blinking amber
Indicates that the hard disk drive is being rebuilt (this status is not a failure). If the
defected hard disk drive is replaced with a new one in the RAID System configuration, the
data is automatically rebuilt (auto rebuild function).
The lamp goes on green when the rebuild is terminated normally. The lamp goes on amber
if the rebuild fails.
IMPORTANT:
To abort rebuilding, power off the server. In such a
case, restart the server, hot-swap the failed hard disk drive, and restart
rebuilding. Observe the following notes to use the auto-rebuild feature.
„
Do not power off the server. (If the server is powered off before
rebuilding hard disk drives, the auto-rebuild feature will not start.)
„
When you removed a hard disk drive, wait at least 90 seconds
before installing the hard disk drive back again.
„
Do not replace another hard disk drive while rebuilding is in
progress.