NEC N8100-1422F, User Manual

Page: 168 / 414

4-100 Configuring Your Server
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switch setting from "Protect" to "Clear".
4.
After three seconds later, reinstall the jumper.
5.
Reassemble the server and then press the POWER switch to turn on the server.
6.
Press F2 during POST to run the BIOS Setup utility, and configure the mother board
again.
Clearing Password
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switch setting from "Protect" to "Clear".
4.
Reassemble the server, and press the POWER switch to turn on the server.
5.
Press
F2
during POST to run the BIOS Setup utility, and set the password again.
6.
Power off the server, and change jumper switch setting from "Clear" to "Protect".
7.
Reassemble the server.