English-19
English
4. Adjust the Overscan ratio (Page 30).
In the OSD Screen, choose [MONITOR SETTING] -> [OVERSCAN], then the appropriate
aspect ratio.
If [FULL (100%)] is chosen, some image may show some noise on the edge.
This noise can be reduced by changing the [OVERSCAN] setting.
Note:
• When an option other than [FULL (100%)] is chosen for [OVERSCAN],
the PIP Function may not be available.
• [OVERSCAN] cannot be adjusted when Through Mode is on.
5. Adjust the screen size (Page 25 and 30).
In the OSD Screen, choose [MONITOR SETTING] -> [SCREEN SIZE], then the appropriate
screen size.
Note:
• This screen size is applied to the image adjusted in the previous steps:
“3 Adjust the screen aspect ratio” and “4 Adjust Overscan ratio.”
• [REAL] and [2X ZOOM] cannot be adjusted when Through Mode is on.
6. In the OSD Screen, choose [MONITOR CONTROL] -> [DV MODE] to change DV Modes
(Page 23 and 30).
7. In the OSD Screen, choose [MONITOR CONTROL] -> [MP MODE] to change MP Modes (Page 23 and 30).
Note:
When [MP MODE] is set at [LEVEL1] to [LEVEL3] the display may flicker.
8. Adjust the volume (Page 27 and 33).
To control audio volume, press the
button on the monitor to either or direction, or press VOLUME Button on the
remote controller, or in the OSD Screen, choose [AUDIO SETTINGS] -> [VOLUME] then the appropriate volume.
To mute the sound, press the middle of the
button.
To cancel mute, press the middle of the
button again.
Playing Games and Watching DVDs
NOTE:
• Connect the game machine and imaging device first (Page 12 to 14) before using these functions.
• For details of connecting and operating a game machine or imaging device, see the documentation supplied with
your equipment.
1. Press the power switch on the monitor front or on the remote controller to switch on the monitor.
2. Press the INPUT/SELECT button on the monitor or a remote controller button in the VIDEO INPUT area to choose
[HDMI1], [HDMI2], [VIDEO1] or [VIDEO2].
Note:
The image may not be displayed immediately when an HDCP-ready device is connected. Wait for several
seconds. If no image is displayed after several seconds, follow the steps below.
• Unplug the signal cable once and reconnect.
• Turn off the imaging device power once, and then turn on again.
3. Adjust the screen aspect ratio (Page 31).
In the OSD Screen, choose [MONITOR SETTING] -> [AV ASPECT RATIO], then the appropriate
aspect ratio.
Note:
• For D1 and D2 (Page 33).
[AUTO], [4:3], [16:9], [16:9 MODE] or [OFF] can be specified. Choose [AUTO] normally.
If the screen is not displayed in a correct aspect ratio in [AUTO] setting, choose the
correct aspect ratio manually.
• For D3, D4 and D5 (Page 31): [16:9], [Side Cut] or [16:9 MODE] can be specified.
• Some settings may not be available when Through Mode is on.
D1 and D2
D3, D4 and D5
Downloaded from ManualMonitor.com Manuals