English-39
English
When the Guidance screen/Precautions screen is displayed (only for when PC input is selected)
Solutions
Connect the signal cable to the monitor or the
computer’s socket properly.
Check whether the signal cable is
disconnected.
Check whether the power of the computer is
turned on.
Move the mouse or press any key on the
keyboard.
Press the DV MODE/RESET button while
[NO SIGNAL] is displayed and check that
proper settings are specified.
Wait for several seconds.
Change the input frequency or the computer’s
resolution.
Change the input frequency or the computer’s
resolution.
Change the resolution of the computer
to 1920 x 1200.
If you want to continue using the same
resolution and not have [RESOLUTION
NOTIFIER] displayed, turn RESOLUTION
NOTIFIER off (so that it is not displayed).
Refer to
Page 11,
12
Page 34
Page 34
Page 29,
33
Page 29,
33
Page 29
Symptom
[NO SIGNAL] is displayed
on the screen!*
1
[OUT OF RANGE] is
displayed on the screen!*
2
[RESOLUTION NOTIFIER] is
displayed on the screen!
Causes
It is possible that the signal cable is not
properly connected to the monitor or the
computer’s socket.
It is possible that the signal cable is
disconnected.
If the power LED is blue and blinking, it is
possible that the computer’s power is turned
off.
The computer’s Power Management function
may be in operation.
DVI EDID SELECT may not be properly set.
If an HDCP-compatible device is connected,
the screen may not be displayed immediately.
It is possible that a signal that is not
supported by the monitor is input.
A signal for a resolution higher than that
supported by the monitor is input.
The resolution signal output from the
computer that you are using is set to a size
other than the recommended sizes.
*1 Depending on the computer, since a regular signal is not output immediately even when the resolution or input frequency is changed, the Precautions screen
may be displayed. However, if the screen is displayed properly after waiting for a while, the input signal is appropriate.
*2 Depending on the computer, since a regular signal is not output immediately even when the power is turned on, the Precautions screen may be displayed.
However, if the screen is displayed properly after waiting for a while, the frequency of the input signal is appropriate.
Other (only for when PC input is selected)
Solutions
Turn off the power of the monitor and the
computer once, and then turn on the power
once again.
Download the Windows
®
Setup Information
from the NEC Web site, and install the
information in your computer.
Reinstall the driver for the graphics board.
For information on reinstalling the driver, refer
to your computer’s operating manual, or direct
your inquiries to the support center for the
computer’s manufacturer.
Refer to
Symptom
The resolution and number
of colors are fixed/cannot
be changed
Causes
Though rare, signals may not be input/output
properly.
If using Windows
®
, it is possible that
installation of Windows
®
Setup Information is
necessary.
If it is still not possible to change the settings
even after installing Windows
®
Setup
Information, or if you are using an OS other
than Windows
®
, it is possible that the driver
for the graphics board is not properly
recognized by the OS.
Downloaded from ManualMonitor.com Manuals