English-43
English
Installing a Monitor Arm
Commercially-available monitor arms that conform to VESA standards (200 mm x 100 mm pitch) can be attached to the
monitor.
TIP:
• Select an arm that can fully support the monitor.
• Make sure that the buttons are not pressed against tables, etc.
NOTE:
This monitor satisfies various specification requirements in the state where the stand is attached.
How to detach the stand
Install a monitor arm in accordance with the following.
1. Turn off the power to the monitor, computer, and peripheral devices, and disconnect the signal cable and the power cable.
2. Place a soft cloth on a flat and stable surface, and lay down the monitor so that the LCD
panel is facing downwards.
TIP:
Lay down the monitor so that it is stable and so that the glass surface and the control
buttons on the front do not come in contact with surfaces such as tables, etc., or
protruding objects. Otherwise, this may result in damage.
3. Remove the 2 screws that fix the stand to the monitor body.
TIP:
If a rear cover is attached, remove the rear cover first (Page 15).
Control buttons
Monitor body (no stand)
Mass
24WMGX
3
Approx. 7.9 kg
4. Remove the stand by sliding it.
5. Remove the 2 screws on the back of the monitor.
TIP:
• If attaching the stand, do so by carrying out the reverse procedure. Make sure to use
the screws that were originally used for attaching the stand. Using other screws may
cause the monitor to malfunction.
• When tightening the screws, make sure not to forget to insert the screws, and confirm
that all of the screws are securely tightened. Attachment of the stand is to be carried
out under the responsibility of the customer. Please note that if an accident should
occur, NEC does not bear responsibility.
Caution:
Be careful not to get your fingers caught when attaching or detaching the stand.
Otherwise, this may result in injuries.
Downloaded from ManualMonitor.com Manuals
