English-16
5. Connecting Headphones.
Headphones can be connected to the headphone output of the monitor.
Caution:
• Do not wear the headphones when connecting them to the monitor
headphones output. Loud noise may damage your ears.
• Do not turn up the volume too high while using
headphones.
Exposing your ears to loud volumes over a long period
may damage your hearing.
NOTE:
• Headphones with a stereo mini jack plug can be used with the monitor.
If your headphone plug is too large, use a commercially available stereo mini jack plug adapter.
• Speaker sound is muted when headphones are connected to the monitor.
6. Install the monitor.
TIP:
Position the mark on the underside of the stand to the front when installing
the monitor. If this mark is not aligned to the front, the monitor will not
swivel equally to the right and left.
7. Turn on the monitor and the computer.
Headphone output
Underside of
the Stand
(Rear)
5. Adjustments.
1. Adjust the Screen.
•
When Digital Connection is Used:
There is no need to perform screen setting adjustment as it is automatically adjusted.
•
When Analog Connection is Used:
Perform Auto Adjust following the instructions in “Performing Auto Adjust (PC Analog Connection Only)” on page 17.
If the display does not function correctly after Auto Adjust, see “Monitor Settings (OSD Functions)” on page 20.
2. Adjust Height and Angle.
Adjust the monitor height and angle to a
comfortable position. Position the monitor as
shown in the figure on the right.
Tilt Angle
Tilt Angle
Swivel Angle
Do not push the
LCD panel surface.
Caution:
• Avoid trapping your hand or fingers between the display and the installation table or the
stand when adjusting the tilt angle and height. May cause an injury.
• The monitor joints may be stiff at the initial tilting and height adjustment. In this case,
hold the top and bottom of the monitor to make the adjustment.
• Do not tilt the monitor greater than 25° while in use, although it is physically possible.
Tilting beyond this degree may cause it to become unstable or cause insufficient
ventilation, resulting in injury or damage to the monitor.
• Set the stand height to the lowest when tilting the monitor beyond 25° for repackaging.
Otherwise, it may fall over resulting in an injury or damage to the monitor.
Also remove the rear cover before tilting.
The cover may become trapped between the back of the monitor and the stand
resulting in damage to the cover.
• Avoid pushing the LCD panel surface while adjusting the height and tilt angle.
This may cause damage, possibly leading to failure or injury.
• Swiveling may not be smooth if the monitor is installed on an uneven surface or at a
low height.
Do not swivel with force or this may damage the installation surface. Lift the monitor
front slightly when swiveling.
NOTE:
The monitor joint becomes stiffer when the tilt angle reaches 25° indicating that this is the
limit for normal use.
Approx. 60 mm
Prohibition
Downloaded from ManualMonitor.com Manuals