5-31
Upgrades and Options
Table 5-1. Option Board Hardware Configurations
OPTION BOARD
IRQ
3
MEMORY
ADDRESS
I/O ADDRESS
OPTION SLOT
DigiBoard (1st)
Not Required
D0000
200
EISA Slot P01
DigiBoard (2nd)
Not Required
D0000
220
EISA Slot P02
SMC 8432BTA (1st)
4
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P05
SMC 8432BTA (2nd)
4
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P06
SMC 9332BDT (1st)
4
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P05
SMC 9332BDT (2nd)
4
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P06
Adaptec 2940UW
2
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P07/P08
5
Mylex DAC960PDU
2
Set by BIOS
Set by BIOS
Set by BIOS
PCI Slot P07/P08
Onboard 7880 SCSI
Set by BIOS
Set by BIOS
Set by BIOS
N/A
2
Onboard 7860 SCSI
Set by BIOS
Set by BIOS
Set by BIOS
N/A
2
1. PCI slot P10 is limited to short PCI option boards because of CPU #2.
2. For disk controllers plugged into slots and the onboard disk controllers, the sequence for BIOS
scanning to determine the primary (Boot) disk controller is:
EISA slots P01 through P04
PCI slot P05 and P06 (primary PCI bus)
Onboard 7880 SCSI (primary PCI bus)
Onboard 7860 SCSI (primary PCI bus)
PCI slot P07 through P10 (peer PCI bus).
It is recommended that the BIOS be disabled on all SCSI controllers except for the controller with the
boot disk drive attached (see The SCSISelect Utilities in the Configuring Your System chapter. This
saves memory address resources and provides control over the boot device independent of board
slot locations.
3. Additional IRQ’s can be made available as follows:
Disabling Comm Port 1 = IRQ4 is available
Disabling Comm Port 2 = IRQ3 is available
Disabling Parallel Port = IRQ7 is available.
4. A maximum of five LAN channels consisting of any combination of single or dual channel. Install
EISA LAN card in the first available EISA slot from the bottom. Install PCI LAN card in the first
available PCI slot from the bottom.
5. A maximum of two SCSI controllers may be installed. Install the first controller card in PCI slot P07
and the second controller in PCI slot P08.
Summary of Contents for MH4000
