NEC MH4000, User Manual

Page: 71 / 204

4-19
Configuring Your System
SCSISelect Configuration Settings
The following keys are active for all SCSISelect
screens:
KEY ACTION
Arrows Up and down arrows move from one parameter to
another within a screen.
ENTER Displays options for a configurable parameter.
Selects an option.
ESC Moves back to previous screen or parameter or
EXIT if at the Main menu.
F5 Switches between color and monochrome.
F6 Resets to host adapter defaults.
Table 4-6 shows the normal settings for the SCSISelect
Utility and provides a place for you to record any
changes you make to these settings.
Table 4-6. SCSISelect Setup Configurations
OPTION
RECOMMENDED SETTING
OR DISPLAY ONLY
YOUR
CONFIGURATION
SCSI Bus Interface Definitions
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Termination Enabled
Additional Options
Boot Device Options Press ENTER for menu
Boot Target ID 0
7
Boot LUN Number 0
SCSI Device Configuration Press ENTER for menu
Initiate Sync Negotiation Yes
Maximum Sync Transfer Rate 40.0
4
Enable Disconnection Yes
Initiate Wide Negotiation Yes
Send Start Unit Command Yes
1
Include in BIOS Scan Yes
1
Advanced Configuration Options Press ENTER for menu.
Reset SCSI Bus at IC Initialization Enabled
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
4
Set to 40.0 for AIC7880 or 10.0 for AIC7860.
7
Set to 0 for AIC7880 or 5 for AIC7860.