NEC MH4000, User Manual

Page: 131 / 204

5-47
Upgrades and Options
Figure 5-20. Removing Side Rails
C
A
B
Removing side rails from
blank panel tray
A Screws
B Side rails
C Blank panel tray
12. Set any device jumpers or switches on the device.
Refer to the installation procedures that came with
the device.
Notice: SCSI termination resistors for the 5 1/4-inch
devices must be installed in the last SCSI device of the
daisy chain cabling (top media bay A). All other 5 1/4-
inch devices must have terminators removed.
13. Using the four screws supplied with the drive,
reinstall the side rails just removed from the blank
panel tray (Figure 5-21, A). Attach the rails to each
side of the device (C) by using only the bottom screw
holes, as shown. The rails for each side of the device
are identical.
14. Engage the device side rails into the bay guide rails
(see Figure 5-22). Ensure that the device side rails
(see Figure 5-22, A) are inside the bay guide rails
exactly as shown in Figure 5-22, B.
15. Push the drive into the bay until the screw holes of
the side rails are directly in front of the chassis
screw holes and secure with the screws previously
removed (see Figure 5-21, C).