I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
4 - 34
Preparing a SCSI Hard Disk Drive
Before installing a SCSI hard disk drive in the system, it should be set as ID0, ID1, ID2
or ID3.
Refer to the instructions printed on the device for further jumper setting information.
Preparing an IDE Tape Drive
Before installing a tape drive in the system, it should be set as a master or a slave
device using the drive select jumper at the back of the drive. Refer to the ‘IDE Device
Configuration’ hereafter for details about configuring IDE drives as master or slave.
Refer to the instructions printed on the device for further jumper setting information.
■
Master Setting
■
Slave Setting
■
Cable Select
Figure 4 - 13 : Connectors on the Back of a Tape Drive (example)
Preparing a SCSI Tape Drive
Before installing a SCSI tape drive in the system, it should be set as ID0, ID1, ID2 or
ID3.
Refer to the instructions printed on the device for further jumper setting information.
