I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
4 - 15
5.
Both holding the HDD bracket and pressing down the latch, gently slide the
HDD bracket out of the chassis.
Figure 4 - 15 : Sliding the HDD Bracket out
6.
The hard disk drive is secured to the bracket with 3 screws located on both
sides of the hard disk drive. Remove these screws, and slide the hard disk drive
out of the bracket.
7.
Set the hard disk drive aside.
Installing a Hard Disk Drive
Caution
Make sure to install hard disk starting from the upper slot.
1.
Refer to the information provided with the hard disk drive for pre-installation
instructions and master/slave/cable select pin configurations. See “Preparing
the Device” on page 4-33.
2.
Remove the right side door. See “Removing the Right Side Door” on page 4-4.
3.
If applicable, disconnect the data and power cables of the installed hard disk
drives.
4.
Loosen the screw (A) securing the HDD bracket and the 3.5/5.25-inch bracket
together.
