NEC Express5800/120Rd-2, Service Manual

Page: 78 / 362

2-14 Setting Up Your Server
Removing the Server from the Rack Assembly
WARNING
At least two persons are required to remove the server from the rack.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Do not attempt to lift the server by yourself. At least two persons are required
to remove the server from the rack.
Do not pinch your finger in the mechanical components.
Do not pull any device out of the rack if the rack is unstable.
Do not pull more than one device out of the rack at one time.
1.
Release the security lock, open and remove the front bezel.
2. Confirm that the server is powered OFF, and disconnect the power cable and all the
interface cables connected to the server.
3. If a cable arm is installed, remove the two screws securing the cable arm to the server
and remove the cable arm from the server.
4.
Loosen the two front thumbscrews securing the server to the rack
5. Holding the handles, slowly and carefully pull the server out of the rack.
A click is heard as the slide rails lock in the extended position.
Security lock