NEC EXP320K, User Manual

Page: 46 / 116

3-6 Installing Server
●
Checking the place to install
Decide the place (height) to install. To keep
balance, install it as low as you can on the rack.
To install the rack, the height for 4U is required.
IMPORTANT:
To install this device to the rack, the space for 1U
is required for installing the USB
compatible floppy disk drive, in addition to the space for 4U.
Next to the square hole of the rack, an imprinted mark is placed for 1U (This is the unit to show the
height of the rack). This device is as high as 4U (about 176 mm), so install it between the imprinted
marks that indicate the height of 4U.
●
Installing this device
Follow the steps below to set the 4U chassis to the rack.
IMPORTANT:
4U chassis weighs about 10 Kg. To mount, remove or replace it, be sure to hold it with two
or more people.
The following are the required accessories. Check if you have them all.
Tool Name Qty
- Bracket 2
- Panhead screw 4
- Washer for panhead screw 4
- Plate screw (short) 8
- Plate screw (long) 4
- Washer for plate screw 12
TIPS:
Core nuts (8 pieces) are not included. Use the core nuts that are attached to the rack.
Imprinted mark
Places to install
core nuts
Imprinted mark (2
imprinted marks for
5Us)
4U (the height for
installing
this
device)
Front side of 4U chassis Back side of 4U chassis