![background image](http://html1.mh-extra.com/html/nec/electraelite-ipk/electraelite-ipk_general-description-manual_3866508094.webp)
2 - 40
Features
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4
Electra Elite IPK
S-4
SEIZED TRUNK NAME/NUMBER DISPLAY
Seized Trunk Name/Number Display shows the programmed telephone
name or number of each trunk in the system. The name or number is
displayed on the Multiline Terminal LCD when a trunk is seized.
S-5
SIMPLIFIED CALL DISTRIBUTION
Simplified Call Distribution is a hunting method that distributes calls evenly to
all members of a hunt group. It is very similar to UCD but does not require
members to control call processing status by logging off. Hunting is instituted
when a DIT, DID, TIE or VRS(4)-U( ) ETU call is terminated at an SCD group
pilot number. Up to 32 SCD members can be divided among four SCD
groups or assigned in one SCD group.
When 5-, 6-, or 7-digit station numbers are used, this feature is unavailable.
S-6
SINGLE POINT OF ENTRY (SPE)
This feature provides a single access point (remote or direct) to configure the
system and/or individual ETUs. The SPE(M)-U( ) ETU provides the same
functions as the MIFM-U10 with the KMM( )-U PAL chip installed or the
MIFM-U20 with the KMM-U20 upgrade chip installed, and comes with a
standard built-in modem. An Ethernet port is provided to allow programming
over a network using TCP/IP.
The SPE(M)-U( ) ETU has six physical COM ports. Two ports go through the
backplane to COM1 for PC Programming and COM2 for SMDR on the side
of the KSU just like the MIFM-U( ) ETU. The other four ports (COM-A,
COM-B, COM-C, and COM-D) are accessible along the front of the ETU to
interface other programmable ETUs (e.g., VMS).
S-7
SINGLE LINE TELEPHONE ACCESS
The Expanded Port Package allows connection of 112 Electra Elite IPK
system Single Line Telephones (SLTs). The Basic Port Package allows the
connection of 24 Single Line Telephones. Single Line Telephone users can
make CO/PBX calls, internal calls, and paging calls.
With R2000 or higher, a Single Line Telephone user can perform a Trunk-to-
Trunk Transfer or make a 1 terminal to 2 outside parties conference call.
With R3000 or higher, Caller ID to Single Line Telephones is supported only
for the incoming outside trunk calls (Loop Start, T1, ISDN, BRI, or PRI).
Send Caller ID Information to Single Line Telephones Class of Service is
added. Version 1.54 is required for the SLIB(4)-U10 ETU to support Caller
ID to Single Line Telephones.
Summary of Contents for ElectraElite IPK
