NEC DT820 ITY-6D, User Manual

Page: 214 / 234

E H S B L U E T O O T H ® H E A D S E T S U P P O R T
Electronic Hook Switch Headset
C -194
DT820 Phone User Guide
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E L E C T R O N I C H O O K S W I T C H H E A D S E T
S U P P O R T E D F E A T U R E S
For supported headsets, the following functions are supported by EHS for DT820
terminals:
• Answering an incoming call
• Go off hook to make an outgoing call.
• Terminate (on hook) a call from the headset
• Mute or unmute the headset microphone.
S E T U P A N D I N S T A L L A T I O N
Before you install the headset base station, the EHS Headset setting on the phone
must be enabled.
Note:
You must have administrative privileges to change the operation mode of the
EHS Headset setting. Contact your network administrator to determine if you
need the setting enabled for your phone.
Headset Base Station Setup
•
Follow the manufacturer’s instructions for assembling your headset and base station.
Enable the Headset port one the phone
1
Press the Menu key on the phone.
2
Select
3
User Settings.
3
Select
2
Headset.
4
Select
1
Enable/Disable.
5
Select
2
Enable.
6
Press Enter
b
on the cursor pad or the OK softkey to accept the setting.
Enable EHS headset at the phoneset device
1
Press the Menu key.
2
Select
4
Admin Settings.
3
Use the keypad and cursor key to enter the User Name and Password to access the
Admin menu.
4
Select
3
Maintenance.
5
Select
4
EHS Headset.
6
Select
2
Enable.
7
Press the OK softkey.
8
Press the Exit softkey.
9
Press the Exit softkey again.
10
Press the Yes softkey to restart the phone.