2. Setting Up Your Projector
60
[5]
Connect the lamp power
supply cable to the LPS and
the projector.
Connect the included lamp power supply
cable to the lamp power supply connector.
Connect the positive (+) side (the cable
wrapped in red tape) to the positive (+)
terminal and the negative (–) side to the
negative (–) terminal.
In case the pedestal (NC-PD02) is used,
the cable inlets (cable inlets on installation
base side and on the projector side) may
be shifted depending on the tilting angle.
Pay attention to the wiring.
[6]
(NC-32PS01 ONLY)
Check the setting of the
input power selection
switch.
Check that the switch is properly set to the
voltage of the AC power supply used.
Caution
Make sure to check that the input power supply selection switch of the
lamp power supply is set properly. Improper setting would cause a failure
of the lamp power supply.
1
2
3
4
5
LAM
P
MEN
U
ENT
ER
DOU
SER
KEY
LOC
K
EXIT
IMB
6
7
8