![background image](http://html.mh-extra.com/html/nec/dlp-cinema-nc3200s/dlp-cinema-nc3200s_installation-manual_250231051.webp)
2. Setting Up Your Projector
51
Common Items
AC Power Supply Cable
- Use a cable having a thickness of 8 AWG or 6 AWG and with a core wire made of copper.
- Use a round type UL-listed solderless terminal for the section connected to the lamp power
supply. In addition, when clamping this terminal with the cable, use an UL listed tool.
- Refer to “Compatible Cables and Solderless Terminals” on the following page for details on the
solderless terminals to use.
- When crimping a solderless terminal onto the cable, ensure that the amount of exposed wire
protruding from the crimped area is a maximum of 2.0 mm.
- Cut off approximately 300 mm of the outer cladding of the power cable from the area of the
solderless terminals, and leave the wires separated.
Compatible Cables and Solderless Terminals
The specifications of the cable mounting terminals of the lamp power supply are as follows:
The following diagram shows the terminal block for the AC power cable.
Power terminals: Black
Ground terminals: Green/Yellow
Solderless terminals and screw fastening torques compatible with the terminal block are
specified below.