2. Setting Up Your Projector
102
[3]
Mount the signal input
board to the projector.
<1> Take hold of the installation handle
on the front of the board, and insert
the board by following the guide on
either side of the slot.
<2> Tighten up the fixed screws (2
places) until it fix.
[4]
Mount the blocking panel of
slot A in the opposite
procedure of removing the
panel.
2.11.3
Mount the Cover to the Projector
Mount the side cover to the projector by the opposite procedure of removing.
This completes the mounting of option board. Next, recover the tamper error. For the procedure
of recovering, refer to “3.2 Recovering from Tamper Errors” (See page 106). A setting to use
option board is needed, after recovering from tamper error. For the procedure, refer to “2.11.4
Setting Up the Projector” (See page 103).
guide
guide
