NEC DLP CINEMA NC2500S, Installation Manual

Page: 35 / 134

NC2500S 2. Settifng Up Your Projector
A-32
2.5.3 Mount the turret
[1]
Remove the anamorphic
lens mounting covers (2
places) of the projector.
You will find fixing holes on the right and left of
the front cover (bottom). On the opposite side
of the lens, you will see a socket for the control
cable.
」
[2]
Mount the slide poles for
the anamorphic lens
motorized turret.
As shown in the figure, fix the slide poles with
two screws using two of four screw holes. In
addition, arrange the slide poles on the right
and left so that they are horizontal.
[3]
Mount the lens carriage.
Move the lens holder to the opposite side of the
primary lens before mounting the lens carriage
to the slide poles.
Insert the lens carriage to a position where the
slide poles get out of the carriage. Pay attention
so that the lens holder does not contact the
primary lens. It may damage the lens.
[4]
Mount the cross balance.
Mount a cross balance with screws (2 screws).
[5]
Fix the slide clamp.
Until the primary lens adjustment is completed,
fix the slide clamp at a position where the lens
holder does not contact the primary lens.
Connect the control cable in the screen ratio
adjustment of the anamorphic lens.
This completes the mounting of the anamorphic lens motorized turret. Mount the
anamorphic lens after completion of the primary lens adjustment.