NEC DLP CINEMA NC2500S, Installation Manual

Page: 86 / 134

Touch Panel 3. Setting Up Your Projector
B-19
[11] Measure the chromaticity [x,
y] of the screen center, then
enter the measured value
into the [x] section and the
[y] section located under
[White].
[12] Save the settings.
Press the "Save" button to display the
file name entry screen. To overwrite an
existing file, check that the file you are
editing is selected before pressing the
"OK" button.
Memo
• It is recommended that you use name "M10I" since it is used for the default file for all of
signal source.
•
When you save your file using filename "M10I", projector will use this data for default
(“M10i” will be applied to all signal sources).
3.3.3 Projecting Red, Green, Blue, and White Colors
By pressing the "Red", "Green", "Blue", and "White" buttons in the “MCGD Setup”, you can
project an image in colors, respectively.
To select a target color (TCGD file), press the “SELECT” button in the “TCGD Setup”.
You can also select a native color of the projector with the “Native” button.