7156 Service Guide
Chapter 7: Disassembling and Reassembling the Thermal Receipt Mechanism
September 1998
75
Note:
If you are replacing the rotating blade, you must change all parts contained in the
knife kit.
1.
Remove the knife home switch assembly.
2.
Remove the set screw and knife actuator arm.
3.
Remove the ground strap connection at the printhead.
4.
Remove the left-hand support and knife blade.
5.
Remove the grip ring from the knife actuator gear with small “E” ring pliers.
6.
Remove the knife actuator gear to gain access to the right-hand support mounting
screws.
7.
Remove the three mounting screws and the right-hand support.
Replacing the Knife Assembly
See the illustration on the previous page.
Note:
Order the knife blade kit. When one part is changed, all parts must be changed. Be
sure to follow the kit instructions to ensure proper break-in of the knife kit. See the Parts
Information Manual for more information about the kit.
1.
Install the new right-hand support with the three screws.
2.
Replace the knife actuator gear with the new grip ring.
3.
Install the new knife blade and new actuator arm.
4.
Install the new left-hand support with the two mounting screws.
5.
Reinstall the knife home switch.
6.
Rotate the knife blade assembly to contact the knife home switch (home position).
7.
Install the new ground strap connecting to both the printhead and the knife blade.
Summary of Contents for 7156
