NARGESA C2006, Instruction Book

Page: 31 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 30
If on the other hand you press the Esc key while you are seeing the message of picture 58 on screen, you’ll
go back to the current block and cell but without having deleted the meter.
Picture 60. Information from the memory block 2 after cancelling the deletion of the meter.
Therefore, each time you wish to erase the meter of the current memory block, just follow the steps
described in this section.
5.11. Menu to operate blocks
This menu allows you to make sequences of cuts previously set through the edition of the different existent
blocks. As it has been previously commented each block has 10 cells as much, the maximum sequence of
cuts has also a max. Capacity of 10 sucessive cuts. We have also to keep in mind that the performance
mode (Manual or Automatic) is the same for all cells in the same block.
5.11.1. Block selection
The following screen appears when acceding the menu for operating with blocks:
Picture 61. Detail of the starting screen of the menu for operating with bloc
In this screen you can make a selection of the block you desire to operate with, pressing the arrow keys on
the keyboard:
There will appear the selected block at each pressing of these keys. In order to find the desired block
quickly, keep the key pressed for more than 1.5sec. Keeping the key pressed, every 0.25 sec it will go to
the next or the previous block.
Once the desired block has been selected, press the Return key, and you will start working with this block.
In case this selected block hasn’t got defined cells in the LCD display will appear one error message during
1 sec indicating that the block is empty.
Picture 62. Attempt to with a block without defined cells
BLOCK 02 0000 AU
CELL 0 = 100.0 mm
BLOCK 02 0000 AU
CELL 0 = 100.0 mm
ATTENTION
EMPTY BLOCK