NARGESA C2006, Instruction Book

Page: 21 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 20
If you desire to make more cuts in this same memory of the top, follow the steps described in this section.
In case you want to make the steps in different sizes, follow the indictaions described in section 5.6.1.
Introducing the desired figure. And once you have done it make again all steps mentioned in here.
5.7.2. Automatic mode
The automatic mode is ususally used when multiple cuts on sheet need to be made in the same figure,
Since it allows to make these operations with only one action, pressing the control pedal of the blade in the
machine.
In order to make more understandable for you, do it by following this example:
Picture 31. Information of the memory of the top 2
Picture 32. Information of the shears in automatic mode.
Acording to the information the LCD shows in both pictures lease, insert the sheet you want to cut. Once
this step has been made press the control pedal to make the blade goes down above the sheet and make
the cut. In this case you can press and loose the pedal, and besides increasing the cuts meter of the
memory of the current top in one unit, it will make a whole cutting cycle. That is to say the blade will go
down to the lower vertical position cutting the sheet. Once at this point it will go back again automatically up
to the upper rest position, and will remain in this position until the pedal is pressed again.
Extrapolating this way of performance to the need of making multiple cuts on the same figure, just press
the pedal and keep it like that. If you do it that way the cuts will be sequentially made and the only thing left
to do is insert the sheet to be cut.
Working as described, in automatic mode, the cutting meterwill be increased in one unit each time the p
edal is pressed or, in the case it remains pressd down, then everytime the shears blade reaches the upper
part.
Picture 33. The meter of the top memory 2 has been increaded.
M02 CONT: 0000
TOP = 56 mm
AUTOMATIC
TOP = 56 mm
M02 CONT: 0013
TOP = 56 mm