NARGESA C2006, Instruction Book

Page: 30 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 29
5.10.7. Deletion of the cutting meter
Another interesting choice of this machine is the chance it gives you to delete the cuts meter from the
different blocks. It is to be kept in mind in this case that the meter will indicate the number of times the
machine has completed one given block, that is to say. It doesn’t show the number of cuts according to the
amount of cuts of sheet made but according to the, complete blocks that have been carried out.
Knowing this peculiarity and according to the action naming this section, follow the information below if you
want to delete the counter:
First of all, go to the edition mode on the block from which you want to remove the cuts meter. For
instance, find block number 2, which shows the following information:
Picture 57. Information from memory block 2
As you can see, the meter of the memory block nº 2 iforms that this has been completed only once. In
order to eliminate this meter, just press the CNT key.
If you do so, you will see a message with the information below appearing in the screen:
Picture 58. Access screen for the deletion of the meter of cuts
If now you press the Return key you will be confirming that you want to delete the current meter, you will
erase it and will go back to the current block and cell but with the meter already set to 0.
Picture 59. Information of the memory block 2 with the meter already deleted.
BLOCK 02 0000 AU
........................ 100 mm
DO YOU WANT TO
DELETE THE METER ?
BLOCK 02 0000 AU
CELL 0 = 100.0 mm