NARGESA C2006, Instruction Book

Page: 24 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 23
Once this operation is finished if you want to try again the accuracy of the Top, you can follow the steps
described up to now in that same section.
On the other hand if when you see the message in Picture 33, you press the Esc key, it go back to the
memory of the top where it was before the machine top correction was made.
5.10. Menus of the block
Apart from the so mentioned 10 memories of the top, the Guillotine C2006 has 50 blocks of memory. Each
of them may have a maximum of 10 cells and at the same time each of these cells may store a cutting
figure for the top.
The blocks have no cells on default, so it is you the one to create them according to your needs. It works
like that due to the great variety of combinations that might be required as for cutting figures when using
the machine. It is due to this reason that it will be much more prectical to work with the blocks you desire,
and that have been created according to the work to be made, than to have blocks aready created which
will not fit your needs and that will have to be modified sooner or later.
Definitely and in such a way that it could be easier to grasp, you should understand the blocks as a set of
top memories that are grouped among them and which allow the user, once they have been created, to
make different cuts on a same sheet, with no need to insert a new working figure after each cutting
operation.
Now that you know the utility and basic composition of the blocks of memories, follow carefully the next
explanation where it is sharply detailed how to accede and work with them.
Locate on each of the 10 memories of the top you have, in such a way that you can see on the LCD display
one information as the one in the picture below:
Picture 41. Information of the memory of the top. 0
Once you do this, press the MENU key and you will see as the information shown on the screen changes
from the one shown in the previous picture into this other one:
Picture 42. Access screen for the menu to operate with blocks
M00 CONT: 0000
TOP TO 500 mm
OPERATE WITH
BLOCKS