NARGESA C2006, Instruction Book

Page: 27 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 26
In order to do get to know how to use both performance modes available correctly, go to a block and edit it.
The screen showing up must indicate the information similar to the one below:
Picture 46. Information about the edition of block 2
Once we reached this point press the Manual and Automatic keys and if you see the upper right part of the
LCD screen, you will notice as it is commuting the performance mode according to the key you are
pressing.
5.10.4. Adding cells
In order to add one cell to the block you are editing it is enough just by pressing the key +. It is to bear in
mind that each new cell added will be always inserted next to the current one and with a top position of
100.0mm on default. If the block is empty, the cell to be added is the first one on the block.
Picture 47. Adding a new cell to the current block.
You can repeat these steps and keep on adding new cells, but you must be concious that there is a limit.
Therefore if you try to add a number of cells higher than 10, the operation won’t be permitted and an error
message will appear in the lower row of the LCD display, just like the one shown in the follwing picture,
during one second time. Once the message has dissapeared, the lower row of the display will show the
current cell again.
Picture 48. Attempt to insert more than 10 cells per block
BLOCK 02 0000 AU
EMPTY BLOCK
BLOCK 02 0000 AU
CELL 0 = 100.0 mm
BLOCK 02 0000 AU
Max. Nº of Cells