NARGESA C2006, Instruction Book

Page: 28 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 27
5.10.5. Eliminating cells
In order to delete one cell of the block you are editing just press the key (-) . It is to bear in mind the fact
that the eliminated cell which is displayed in the lower row of the LCD display, will be moving automatically
the cells next to the one eliminated.
If you try to eliminate any cell when the block is empty, the operation won’t be able to be carried out and it
will appear on the low row of the LCD display an error message like the one shown in the following picture,
during 1 sec time. Once this error message disappears, the lower row of the LCD display will show a
message indicating that the block is empty again.
Picture 49. Attempt to eliminate cells with the block empty.
5.10.6. Edition of cells
Despite the fact that when adding cells this are preset to put the top to 100.0mm, it is quite probable to
require intermediate figures which are not reflected in these memories.
So, to enter the desired figure it is enough just by inserting the the new value for the top positioning using
the number key. Once the desired value has been introduced, press the Return key to cofirm the new
position.
Let’s see an example of the steps to follow, the new figure is 443.2 mm:
Picture 50. Edition of the memory block 2
When pressing the first number (5 in this case), the message on screen changes into this other one.
Picture 51. Inserting a new figure
BLOCK 02 0000 AU
Max. Nº of Cells
BLOCK 02 0000 AU
Cell 9 = 100.0 mm
BLOCK 02 0000 AU
........................ 5 mm