NARGESA C2006, Instruction Book

Page: 23 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 22
5.9. Correct the top
The choice to correct the top of the machine allows you to make the right adjustment of the top positioning.
In order to go no with this operation, whenever you are at any of the ten memories of the top, just press the
Correct Key. When you do that in the LCD display will show the information detailed in the follwing picture:
Picture 38. Control screen to accede the correction of the shears top
Here to be able to accede to the correction of the top, you must insert PassWord 44223311 and press the
Return key.
If the password inserted is not the correct one, when you press the return key, the effect will be that one
occurring when you press the Esc key, that is to say, it will go back immediately to the memory of the top it
was before pressing the Key to correct the top of the Guillotine.
In case you have inserted the correct PassWord we have indicated, you’ll see how it will show up the
following message on the LCD display, at the same time the top starts moving looking for the figure
detailed in it:
Picture 39. Information of the positioning of the top for the correction.
Likewise, the top will move to locate on the figure 100.0 mm (Correction figure), its current position could
be seen in the 7 fragments display. In the moment the top reaches that figure, it stops and in the screen it
will show up a label like the one below:
Picture 40. Pantalla para introducir la corrección del tope
When you spot the previous messageyou should check up if the top is really at figure 100.0mm, helped by
an accurate tool. If it is so, then just press the Return key to cofirm the correction.
In case the current figure is different from 100.0mm, it is necessary to insert the figure you have inserted
and press th e Return Key to confirm the correction.
When you do that the machine will re-start following the process described in section 5.3. Feeding of the
Guillotine C2006
INSERT PASSWORD
... ...
POSITIONING
TOP TO 100 mm
POSITIONING
TOP TO 100 mm