NARGESA C2006, Instruction Book

Page: 33 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 32
6. ADJUSTMENT OF THE BLADES
Whenever you are in any of the 10 preset memories of the top, you can accede to the menu for the Blades
adjustment. In order to do that just press the Menu Key. Then you’ll see the following message in the
display:
Picture 66. Access screen for the Menu to operate with blocks
Now with the help of the navigation keys go to the option indicated in the following picture:
Picture 67. Access screen for the menu to adjust blades.
When you see this information press the Return key and you will accede the menu to make the blades
adjustment, the following message will show up on screen:
Picture 68. Information screen for the blades adjustment.
In order to make the blades adjustment of the machine just press the pedal for the big cutting part to
descend gradually. If you stop pressing the pedal while it is goig down, this one will stop. You may go on
with the adjustment by fastening the pedal again.
Know that once you have reached the lower rest position of the big cutting part, this one will not go on
descending even if you keep the pedal pressed. Likewise, while you keep the pedal pressed, you will never
get it back to the upper rest position. So press the Return and Esc keys whenever the pedal is not pressed.
When you press the Return key, the big cutting part will move upwards until it reaches the upper rest
position, whenever the pedal is not pressed. If you do so this part will descend again while the pedal is
pressed. Once this part has reached the upper rest position, you could check up again the blades
adjustment repeating the steps previously described.
If on the other hand you press the ESC key, the big cutting part will make an upwards movement until it
reaches the upper rest position. In this case, it doesn’t matter if you try to press the pedal since the actions
you perform with it are not to be taken into consideration at the moment. Moreover, when the big cutting
part is in its correct position, it automatically will go back to the preset top memory in which it will be before
acceding to the menu for adjusting the blades.
OPERATE WITH
BLOCKS
ADJUST
BLADES
Making the blades
Adjustment