NARGESA C2006, Manual, Page: 37 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 36
5.22. Touch screen calibration
The touch screen has been correctly calibrated at the factory. However, it may need to be re-calibrated if it
does not seem to respond correctly to the operator’s actions.
Press the button to access the menu window. Once within the menu, press the button. The
message displayed below will appear on doing so:
To accept, press , and the touch screen calibration process will start. At this point, the information
displayed on the screen changes to the following:
There is a cross in the centre of the screen which should be pressed for a few moments until it moves to a
new position. This process is repeated at various points on the screen until the calibration process is
complete.