NARGESA C2006, Manual, Page: 27 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 26
Select the “Axes” option from this window. Once selected, look for the line displayed below.
Select the level that has been set as the homing cycle zero position and add or subtract the difference
obtained in the previous step. In this case the resulting level is that displayed below.
Repeat the same process to check that the new zero-gauge position is correct.
5.12. Blade adjustment
The blades are adjusted perfectly at the factory; however, they may need to be replaced after numerous
cutting operations due to wear. In order to ensure efficient cutting, the blades must be adjusted accordingly
once they have been changed. Follow the procedure detailed in the corresponding section to do so, after
enabling the blade adjustment mode.
During this operating mode, the upper blade is lowered when the pedal is pressed. When the pedal is
released, the blade stays in the same position. The pedal can therefore be used to lower the upper blade in
a controlled way, and it can be adjusted as required once in position.
The blade adjustment mode can be accessed from both the manual and automatic operating modes. To do
so, press the button. On doing so, the icon changes to , indicating that the machine is in the
blade adjustment mode.
Once the blades have been adjusted, press the button again to disable the blade adjustment mode
and return to the standard operating mode .
Note that on doing so, the shears automatically return to the previous position by raising the upper blade up
to the maximum machine opening position.